|
|
TM 9-2815-224-34&P
Engine Governor Maintenance Instructions (Cont)
15-7.
BUFFER SCREW SWITCH REMOVAL/REPAIR/INSTALLATION (CONT).
b. Disassembly,
NOTE
Disassembly pertains to Model A switch
only.
Remove retaining ring (1),
(1)
washer (2), plunger (3),
spring (4), and preformed
packing (5) from plunger
assembly (6).
Remove locknut (7), locking
(2)
ring (8), and nut (9) from plunger
assembly (6).
Remove two screws (10), clamp (11),
(3)
bracket (12), clamp (13), and two
washers (14).
Remove two screws (15) and lockwashers (16)
(4)
with two terminals (17), diode wire (18), and
lockwasher (19) from switch (20).
C.
Cleaning/Inspection.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. `lb avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
Clean all metal parts with drycleaning solvent.
(1)
Inspect parts for defects.
(2)
Replace defective parts and all packings.
(3)
Coat all metal parts with oil.
(4)
15-28 Change 2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |