Assembly-continued - TM-9-2815-224-34-P0405

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

(33) Support weight earner (42) in center and press shaft (41) into

weight carrier.

(34) Press two bearings (43) in weight (44).

NOTE

Repeat steps (35) and (36) for other weight.

(35) Install weight (45) and two washers (46).

(36) Install pin (47), two washers (48), and two

retaining rings (49).

(37) Install governor housing

bearing (50) in governor

housing (2).

(38) Install governor riser (51) on

governor weight shaft (41).

(39) Install governor riser thrust

bearing (52), smaller inside

diameter first, against governor

riser (51).

(40) Support spline end of governor

weight shaft (41) on bed of press.

Set governor housing (2) over

governor weight shaft and press

housing on shaft.

15-13