 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2815-224-34&P
Blower and Water Pump Drives Maintenance Instructions (Cont)
10-2. BLOWER DRIVE SUPPORT REMOVAL/REPAIR/INSTALLATION (CONT).
e. Installation.
NOTE
Apply light coat of grease to both sides of
gasket.
(1) Install gasket (1) and blower drive
assembly (2) in flywheel housing (3).
(2) Install two screws (4) and copper washers (5).
(34 to
(3) Tighten two screws (4) to 25 to 30
(4) Install crossover pipe (6), two
(7), and screws (8).
(5) Tighten clamp (9).
Used gear backlash cannot be over 0.010-in. (0.25 mm).
New gear backlash will measure 0.002-in. (0.05 mm) to
0.008-in. (0.20 mm). If backlash cannot be checked at face
of blower drive gear, check at accessory drive hub.
(6) Check backlash between blower drive gear (10) and
right bank camshaft gear (11).
END OF TASK
10-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals