Removal-continued - TM-9-2815-224-34-P0153

TM 9-2815-224-34&P

Flexplate and Flywheel Housing Maintenance Instructions (Cont)

Remove crankshaft rear oil seal (52)

(27)

from flywheel housing (1).

CAUTION

Use care not to damage crankshaft when

removing crankshaft rear oil sleeve.

NOTE

Rear oil sleeve may not be present on

crankshaft.

(27.1) Remove sleeve (52.1) by splitting with a

chisel and hammer.

(28) Remove gasket (53) from engine block rear

end plate (54) and flywheel housing (1).

CAUTION

Crankshaft must be clean and smooth or oil

seal lip will be damaged when flywheel

housing is installed.

NOTE

Polishing motion should be clockwise around

end of crankshaft.

Polish end of crankshaft (55) with

(29)

crocus cloth wet with lubricating oil.

Lubricate gear train teeth (56) with

(30)

lubricating oil.

Remove four alining studs from engine

(31)

block (49).

Remove lifting eyes.

(32)

Change

5-9