Removal-continued - TM-9-2815-224-34-P0122

TM 9-2815-224-34&P

Crankshaft Maintenance Instructions (Cont)

14-5. MAIN BEARING AND CRANKSHAFT REMOVAL, REPAIR, AND INSTALLATION (CONT).

(7) Install two screws (7) in front main

bearing cap (10) and rear main

bearing cap (11).

(8) Tighten four screws (7) to 50 lb-ft

(5.65 Nm).

(9) Strike front main bearing cap (10)

and rear main bearing cap (11) with

soft-face hammer.

(10) Tighten four screws (7) to 110 lb-ft

(12.43 Nm).

(11) Strike front main bearing cap (10)

and rear main bearing cap (11) with

soft-face hammer.

(12) Tighten four screws (7) to 250 to

260 lb-ft (28.25 to 29.38 Nm).

(13) Install spacer (12) and

screw (13) on front of

crankshaft-(2).

NOTE

Bearing caps are numbered from

1 to 5 for later installation.

(14) Remove three center bearing

caps (14).

NOTE

If bearing shells will be reused, tag and mark them for installation.

(15) Remove lower bearing shells (15) from three center bearing caps (14).