 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TESTS AND ADJUSTMENTS (CONTINUED)
I
GLOW PLUG TEST
Touch exposed end of wire lead to glow plug terminal.
D
NOTE
If no spark, glow plug is defective.
E
Do not attempt to repair or adjust glow plugs. If
glow plugs are defective, replace with new plugs
F
Turn MASTER and PREHEAT switches OFF.
and gaskets.
G
Slide insulating sleeve over terminal end of wire lead.
Disconnect wire lead at no. 1 cylinder.
H
Connect wire lead to no. 1 glow plug.
Turn MASTER and PREHEAT switches ON.
I
Repeat steps A-H for no. 2 glow plug.
Slide insulating sleeve back to expose terminal end of wire lead.
ADJUSTMENT
NOTE
Remove and discard rocker arm cover gasket (p 3-31).
c"
Allow engine to cool to room temperature (about
75 `F) before adjusting valves.
to 44
D Check that cylinder head bolts are
(minimum).
Disconnect breather hose at rocker arm cover.
E Remove cylinder shroud door panel
3-5) to observe timing
Remove rocker arm cover and lifting bracket as unit (p 3-31,
pointer.
steps C-E).
TM
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals