CLEANING -- CYLINDER BLOCK

REPAIR (CONTINUEDI

---- -- . . . .

-------- --- --- ----

WARNING

E Soak rear bearing plate in clean receptacle containing rust

preventive (item 13, Appx C).

Particles blown by compressed air can be

dangerous. Direct air stream away from all per-

Dry rear bearing plate as in steps C and D.

sonnel in immediate area.

G Coat rear bearing plate with oil (item 16, Appx C).

D Air dry oil bypass port and all threaded holes with clean,

filtered,

compressed air.

CLEANING -- CYLINDER

C Clean all gasket and bearing surfaces with a stiff brush

soaked in dry-cleaning solvent (item 8, Appx C).

WARNING

all holes and recesses.

1Dry-cleaning solvent used to clean parts is poten-

tially dangerous to personnel and property. Do

WARNING

not use near open flame or excessive heat.

point of solvent is 138 "F.

Particles blown by compressed air can be

[

dangerous. Direct air stream way from

in immediate area.

A Clean inside and outside of cylinder block with dry-cleaning

solvent (item 8, Appx C) or mineral spirits paint thinner

(item 21, Appx

E Air dry oil passages with clean, filtered,

compressed air.

B Clean out oil passages with cleaning wire. Flush with

Wipe cylinder block dry with clean, lint-free cloth (item 6,

cleaning solvent (item 8, Appx C) or mineral spirits paint

thinner (item 21,

1244