 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 CRANKSHAFT AND GEARCASE BACKPLATE REPAIR (CONTINUED)
Install rear bearing plate (6) and thrust bearing washer (5)
K
Remove rear bearing plate (6) and thrust bearing washer (5).
1
with six bolts (9) and six new hardened washers (10).
NOTE
Torque bolts to 40-45
L
When using metal shims,
paper
gaskets must be installed on each side of shim.
NOTE
To avoid too much gasket compression and
Improper shim thickness or thrust washer
maintain bolt torque, do not allow paper gasket
may cause crankshaft to bind.
thickness to exceed 0.015 inch.
M Rotate crankshaft (4) and check for binding.
Install or remove new paper gaskets (7) and steel shims (8)
J
as required to provide 0.010-
clearance.
Coat new
gasket with adhesive sealant
1,
N
o
Press gasket into place on cylinder block over locating pins.
1237
TM 9-2815-221
3-129
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals