CHAPTER 3. MAINTENANCE PROCEDURES - TM-9-2815-221-34-P0039

MAINTENANCE PROCEDURES

CHAPTER OVERVIEW

This chapter consists of the following sections:

This chapter contains detailed instructions for removal, disassembly,

cleaning, inspection, repair, assembly, test and installation of Model

Section I General Information

DJEAM and Model DJBMA diesel engine components.

Section II Maintenance Instructions

Section I GENERAL INFORMATION

This manual does not cover Crew or Organizational Maintenance.

CLEANING

Refer to TM 9-2350-267-10 or TM 9-2350-267-20 if necessary. (Refer to

TM 9-2350-256-10 or TM 9-230-256-20 for

Disassemble engine to major components in accordance

with instructions in this chapter.

Disassemble only to point of malfunction or defect. Replace only parts

Clean all parts thoroughly.

necessary to correct problem.

install mandatory replacement

parts required at that point of disassembly.

Identify part location in engine.

NOTE

Keep engine parts, tools and special equipment clean during

maintenance procedures.

All torque

values given in these procedures apply

to lubricated threads.

Cover

cleaned parts to protect them from dust and dirt.

WARNING

During reassembly of internal engine components, coat all

parts heavily with crankcase grade oil (LO 9-2350-267-12).

Compressed air used for cleaning will not exceed

(For DJBMA, use LO 9-2350-256-12.)

30 psi. Use only with effective chip-guarding and

personal protective equipment such as goggles,

shield and gloves.

0827

TM 9-2815-22

3-1