CHAPTER 1. INTRODUCTION - TM-9-2815-221-34-P0009

INTRODUCTION

S e c t i o n I GENERAL INFORMATION

SCOPE

A P P E N D I X A is a list of current references,

including supply

This technical manual has instructions for Direct/General Support

manuals, forms, and other applicable publications.

Maintenance of the Diesel Engine Assembly, Model DJEAM, used on

the Carrier, Ammunition, Tracked, M992; and Model DJBMA used on

APPENDIX B is the Repair Parts and Special Tools List, with ap-

the M88A1 Medium Recovery Vehicle.

plicable illustrations, required to support the diesel engine assembly.

Steps in which maintenance procedures are to be performed are in-

APPENDIX C lists Expendable Supplies and Materials required to

dicated by letters: step A is performed before step B, and B before C.

support the diesel engine assembly maintenance functions.

Step AA follows step Z.

APPENDIX D lists torque limits for the diesel engine assembly.

Text and illustrations use numbers to help you identify parts. Exam-

ple: to tell how to remove the screws and washers in the picture below,

your instructions would be:

MAINTENANCE FORMS, RECORDS AND REPORTS

Remove eight screws (1) and washers (2).

Department of the Army forms and procedures used for equipment

maintenance will be those prescribed by DA Pam 738-750, The Army

Maintenance Management System (TAMMS).

Accidents involving injury to personnel or damage to materiel will be

reported on DA Form 285 (Accident Report) in accordance with

AR 385-40.

METRIC TOOLS

Diesel Engines, Model DJEAM and DJBMA, described in

this

manual are non-metric. Use of metric tools is not required.

Dotted lines on illustrations indicate where parts are located.

TA310813

TM 9-2815-221-34&P