Figure 3-72. Air compressor drive gear timing mark.

*TM 9-2815-213-34

(b) Remove plate (16), packing (17), nylon washer

(d) Remove sleeve bushing (29) and drive shaft

(18), diaphram (19), O-ring (20), body (21), and seal ring

gear (28).

(e) Remove weight pivot pins (24) and hollow pin

(22).

(3) Mainshaft Cover and Governor Assembly (fig. B-

shafts (25), supporting governor weights (26), and thrust

18).

washers (20).

(a) Remove six capscrews, lockwashers, and plain

(f) Remove weights, washers, compression spring

washers (33, 34, and 35) securing main shaft cover and

(21), flat shimming washers (22), and weight assist

governor assembly to pump housing.

plunger (23).

(b) Using fuel pump governor weights puller (28, fig.

(g) Remove capscrew (7), lockwasher (8), flat

B-28), remove governor weights assembly (19) from

washer (9), and hub (10) securing drive assembly to

cover as shown in figure 3-75.

cover.

NOTE

carrier shaft (27).

The hub is keyed to the shaft by key (18).

(h) Remove tachometer drive gear (16),

3-37