Section XI. REBUILD OF FLYWHEEL HOUSING, FLYWHEEL ASSEMBLY AND TRANSMISSION ADAPTER

Section XI. REBUILD OF FLYWHEEL HOUSING, FLYWHEEL

ASSEMBLY AND TRANSMISSION ADAPTER

207. FLYWHEEL HOUSING

N o t e . The key letters shown below in paren-

theses refer to figure 395 except where other-

wise indicated.

a . Disassembly. Disassemble the flywheel

housing following instructions on figures 396

and 397.

FIGURE 397. REMOVING OR INSTALLING

PIPE PLUG (EARLY MODEL ENGINES).

FIGURE 396. REMOVING OR INSTALLING

PIPE PLUGS (LATE MODEL ENGINES).

b. Cleaning and Inspection.

(1) Cleaning. Clean the flywheel housing

( F - 2 ) as directed in paragraph 152 c .

(2) I n s p e c t i o n . Inspect the flywheel hous-

ing (F-2) directed in paragraph 153 b .

c . Repair. Repair the flywheel housing (F-2)

a s directed in paragraph 154 b . Repair studs

(F-1, F-3, F-4, and F-7) as directed in para-

graph 154d.

d. Assembly. Refer to figures 396 and 397

a n d- reverse the sequence of instructions to

FIGURE 398. REMOVING RING GEAR FROM

install the pipe plugs.

FLYWHEEL.

208. FLYWHEEL ASSEMBLY

--. Cleaning and Inspection.

Note. The key letters shown below in paren-

theses refer to figure 395 except where other-

(1) Cleaning. Clean the flywheel assembly

wise indicated.

(K) directed in paragraph 152 c .

248