|
|
Section X. REBUILS OF CYLINDER HEAD COVERS, BREATHER TUBE
ADAPTER, CRANKCASE BREATHER TUBE , AND RELATED PARTS
N o t e . Early model front cylinder head covers
incorporated a screen soldered to the lower end
N o t e . The key letters shown below in paren-
of the oil filler tube. If screen is present, un-
theses refer to figure 393 except where other-
solder and discard screen.
wise indicated.
--. Cleaning and Inspection.
a
(1) Cleaning. Clean the oil filler cap (H)
with warm water and soap. Clean the
N o t e . The key letters shown below in paren-
front and rear cylinder head covers
theses refer to figure 393 except where other-
(J and C) as directed in paragraph 152 c.
wise indicated,
(2) I n s p e c t i o n . Inspect the front and rear
a . Disassembly. D i s a s s e m b l e the breather
c y l i n d e r head covers (J and C) for
tube adapter and rubber hose following instruc-
cracks and dents. Inspect the oil filler
tions on figure 394.
cap (H) for cracks and damage to lock
tabs on inside of cap. Inspect sealing
--. Cleaning and Inspection.
b
gasket inside of cap for tears or dam-
a g e that would prevent a tight seal.
(1) C l e a n i n g . Clean the breather tube a-
dapter (E), and hose clamps (K) as
directed in paragraph 152 c . Clean the
b . Repair. Straighten minor dents in front
rubber hose (L) with warm water and
and rear cylinder head covers (J and C). Re-
soap.
place cracked or severely dented cylinder head
c o v e r s . Replace the oil filler cap (H) when
(2) I n s p e c t i o n . Inspect the breather tube
c r a c k e d , lock tabs are damaged, or gasket is
damaged.
adapter (E) as directed in paragraph
c r a c k s , hardening, and set condition,
Inspect hose clamps (K) for cracks
and bends.
c . R e p a i r . Repair the breather tube adapter
( E ) as directed in paragraph 154 b . Replace
t h e rubber hose (L) when cracked, hardened,
or in a set condition. Replace the hose clamps
(K) when cracked or bent.
d . Assembly, Refer to figure 394 and reverse
the sequence of instructions to assemble the
breather tube adapter and rubber hose.
N o t e . The key letters shown below in paren-
theses refer to figure 393 except where other-
wise indicated.
a . Disassembly. N o d i s a s s e m b l y o f t h e
BREATHER TUBE ADAPTER AND RUBBER
crackcase breather tube is required.
HOSE.
246
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |