 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 A - Timing gear cover gasket
M - Crankshaft damper and pulley assembly
B - Timing gear cover assembly
1- 3/8 x 7/8 cap screw
1- Timing pin
2- 3/8-in. lock washer
2- Cover
3- Damper
3- 3/8 x 1-5/8 plain stud
4- Pulley assembly
C - 3/8 x 1-1/4 cap screw
a - 3/8 x 3/4 dowel pin
D - 1/2 x 2-3/4 cap screw
b - 7/16 x 3/4 dowel pin
E - Adapter gasket
c - Pulley
F - Tachometer take- off adapter
N - Retaining plate
G - Tachometer adapter assembly
P - Crankshaft bolt
1- Adapter shaft
Q - Crankshaft bolt lock plate
2- Tachometer adapter
R - Crankshaft bolt lock plate 3/8 x 3/4 cap
H - 3/8- in. lock washer
screw
J - 3/8- in. plain nut
S - 3/8- in. lock washer
K - Injection pump drive gear access cover
T - 3/8- in. lock washer
gasket
U - Crankshaft front oil seal
L - Injection pump drive gear access cover
V - 3/8- in. lock washer
PARTS - EXPLODED VIEW.
(2) Figure 355. (A) Position oil pump idler
gear on press plates with bearing re-
Note. The key letters shown below in paren-
taining ring groove side of gear down.
theses refer to figure 351 except where other-
(B) Remove idler gear bearing from oil
wise indicated.
pump idler gear using suitable pressing
arbor.
a. Disassembly. Remove bearing from oil
b. Cleaning.
pump idler gear (E E) as follows.
(1) Refer to paragraph 152b for general
(1) Refer to figure 354 and remove bearing
cleaning instructions for the oil pump
retaining ring.
idler gear (EE).
220
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals