 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 145. REMOVAL OF FLYWHEEL HOUSING
a. General. The flywheel housing is mounted
at the rear of the cylinder and crankcase as-
sembly.
b . Removal. Figure 299. (A) Remove two
1/2-inch plain nuts and 17/32 x 1/8 thk flat
washers. (B) Remove six 1/2-inch plain nuts and
17/32 x 1/16 thk flat washers securing flywheel
housing to cylinder and crankcase assembly.
(C) Remove flywheel housing.
FROM OVERHAUL STAND.
(2) Figure 298. (A) Position support blocks
between cylinder head studs as shown.
(B) Lower engine assembly on blocks
and remove sling.
FIGURE 298. STRIPPED ENGINE POSI-
FLYWHEEL HOUSING.
TIONED ON SUPPORT BLOCKS.
179
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals