FIGURE 84. REMOVING OR INSTALLING AIR COMPRESSOR ADJUSTING FLANGE AND PULLEY

(2) Figure 85. (A) Install the 3/4- inch self-

locking nut on air compressor shaft.

Tape Woodruff key in position to pre-

vent loss. (B) Remove two 5/16 x 1-3/4-

inch hex head bolts and 5/16- inch lock

washers and remove discharge housing.

Remove and discard discharge housing

gasket. (C) Remove two 5/16 x 3/4-inch

hex head bolts and 5/16-inch lock

washers and remove intake manifold.

Remove and discard intake manifold

gasket.

FIGURE 86. AIR COMPRESSOR ASSEMBLY

WITH AIR DISCHARGE HOUSING AND

AIR INTAKE MANIFOLD

INSTALLED .