 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 62. TURBOSUPERCHARGER
(3) After installation of generator assem-
bly, adjust engine fan and generator
A. Removal. Turbosupercharger removal
drive belt deflection as follows.
from early and late model engines differs. Re-
move turbosupercharger as follows, referring
(4) Figure 43. (A) Loosen 3/8 x 7/8 cap
screw securing generator adjusting
to the illustrations applicable to the model
engine as noted.
strap to generator assembly. (B) Pull
generator assembly away from engine to
(1) Figure 44. (A) Loosen 1-1/4-inch hose
decrease engine fan and generator drive
clamp securing rubber hose to breather
belt deflection or push generator toward
tube. (B) Remove 1/4- inch plain nut and
engine to increase belt deflection. (C)
1/4- inch lock washer securing crank-
Apply pressure on each drive belt to
case breather tube to turbosupercharger
determine deflection. Proper deflection
is 3/4-inch applied at midpoint between
bracket. (C) Remove crankcase breather
tube.
water pump pulley and generator pulley.
(D) Check tightness of the two 7/16-
inch plain nuts and 7/16 x 1- 1/2 cap
(2) Figure 45. (A) Remove 5/16- inch plain
screws attaching generator assembly to
generator mounting bracket after final
adjustment is made. (E) Tighten the
3/8 x 7/8 cap screw to secure generator
adjusting strap to generator and to
maintain proper belt deflection. Both
engine fan and generator drive belts
must have equal deflection. Engine fan
and generator drive belts are furnished
as a set.
CRANKCASE BREATHER TUBE
( LATE MODEL ENGINES).
62
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals