Figure 6-70. Removing or installing oil pump driven gear attaching parts and

Remove

1. Remove cotter pin (A).

Remove

2. Remove slotted nut (B).

1. Cut locking wire (A).

3. Remove and discard two preformed packings (C).

2. Remove two bolts (B).

4. Remove and discard preformed packing (D).

3. Remove lock plate (C).

Install

1. Install new -in. preformed packing (D) in pump

1. Position lock plate (C) on scavenge housing cover.

housing.

2. Install two bolts (B) securing plate to cover.

2. Install two new 1-in. preformed packings (C) in pump

3. Install locking wire (A).

housing.

3. Install slotted nut (B) securing oil pump driven gear.

Figure 6-71. Removing or installing oil pump

4. Install cotter pin (A) securing nnt (B).

drive shaft lock plate (FSN 2815-895-6430

oil pump).

Figure 6-70. Removing or installing oil pump

d r i v e n gear attaching parts and

preformed packing.

6-77