 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
CAUTION
Eccentric ring, outer rotor, spring, and vane
may fall out when removing plate assembly.
Equipment damage can result.
Inner and outer rotors must stay a matched
set. Damage to equipment can occur.
4. REMOVE PUMP PLATE ASSEMBLY (1).
a. Turn liquid pump housing (2) over.
b. Carefully break loose oil suction
between plate assembly (1) and
housing (2).
Hold eccentric ring (3) and outer
c.
rotor (4) in place while removing
plate assembly (1).
5. CHECK PLATE ASSEMBLY (1).
a. Using telescoping gage set and
micrometer caliper set, measure
inside diameter of sleeve bushing (5).
b. If diameter of sleeve bushing (5) is
greater than 1.002 inches (25.45 mm),
go to step 5.1. If not, go to step 6.
REPLACE PLATE ASSEMBLY (1).
5.1
RECORD FAILURE ON DA FORM 2407
6. REMOVE SHOULDERED SHAFT (6)
AND RETURN DEFECTIVE PLATE
AND INNER ROTOR (7).
ASSEMBLY TO DEPOT.
GO TO NEXT PAGE
4-475
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals