 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
8. CHECK TWO PISTON BORES (1).
a. Using micrometer caliper set and
telescoping gage set, measure two
inside diameters of piston bores (1).
b. Replace brake piston housing (2)
if either measurement is greater than
2.122 inches (53.90 mm).
9. REPEAT STEP 8 FOR REMAINING
BRAKE PISTON HOUSING (2).
10. C L E A N SECOND RANGE SINGLE
DISK BRAKES.
a. Clean housings (2) and piece parts.
See page 2-2.
11. I N S P E C T SECOND RANGE SINGLE
DISK BRAKES.
a. Inspect housings (2) and piece parts.
See page 2-5.
ASSEMBLE
12. INSTALL ONE PLUG (3) IN
EACH HOUSING (2).
a. Coat new preformed packing (4) with
transmission oil.
b. Install packing (4) on plug (3).
c. Using 3/8-inch drive ratchet handle and
3/16-inch socket wrench attachment,
install plug (3).
d. Repeat steps 12a through 12c for
remaining plug (3).
13. USING 3/8-lNCH DRIVE TORQUE
W R E N C H AND 3/16-lNCH SOCKET
W R E N C H ATTACHMENT, TORQUE
PLUGS (3) TO 110-120 in-lb
(127-138 cmkg).
GO TO NEXT PAGE
4-443
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals