 |
|||
|
|
|||
|
Page Title:
CHECK DIRECTIONAL CONTROL SLIDE |
|
||
| ||||||||||
|
|
 TM 9-2520-270-34
14. CHECK DIRECTIONAL CONTROL
SLIDE (1).
a.
Using micrometer caliper set, measure
two diameters (2).
15. CHECK RING (4).
Replace slide (1) if measurements are
b.
a. Using telescoping gage set and
less than 1.1237 inches (28.542 mm).
micrometer caliper set, measure bore of
ring (4).
Measure diameter (3).
c.
b. Replace ring (4) if bore measurement is
Replace slide (1) if measurement is less
d.
greater than 1.0015 inches (25.438 mm).
than 0.9987 inch (25.367 mm).
NOTE
Two types of dashpots are in use with this valve
assembly.
15.1 INSPECT DASHPOT AND DETERMINE
TYPE.
a. If dashpot is type (5), go to step 15.2.
b. If dashpot is type (6), go to step 16.
GO TO NEXT PAGE
4-410.1(4-410.2 blank)
Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals