 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
3. IF ANY BRAKE ACTUATING PLATE
INSERT (1) WAS REPLACED, GO T O
STEP 4. IF NOT, GO TO STEP 6.
4. TURN PLATE (2) OVER.
a. Inspect back of plate (3) where new
insert(s) (1) was installed.
b. If insert(s) (1) caused back of plate (3)
to deform, go to step 5. If not, go to
step 6.
5. HONE RAISED AREA (4) OF
PLATE (2).
a. Using fine honing stone, hone raised
area(s) (4) on bottom of plate (2) until
surface is flat.
6 . CLEAN ALL INSERTS AND RELATED
HOUSINGS.
a. Clean assembly and hardware. See
END OF TASK
4-351
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals