 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
36. REMOVE RETAINING RING (2)
AND WASHER (1).
35. CHECK GAP BETWEEN WASHER (1)
a. Using retaining-ring pliers, remove
AND RETAINING RING (2).
retaining ring (2).
a. If gap is 0.006 to 0.013 inch
b. Remove washer (1).
(0.15 to 0.33 mm), go to step 37.
If not, go to step 36.
c. Go to step 20.
38. INSTALL EIGHT SCREWS (8).
a. Using 3/8-inch drive ratchet handle
with extension and 7/16-inch socket,
install eight new lock washers (9)
and screws (8).
39. USING 3/8-lNCH DRIVE TORQUE
WRENCH WITH EXTENSION AND
7/16-lNCH SOCKET, TORQUE EIGHT
SCREWS (8) TO 75-100 in-lb
(86-115 cmkg).
37. INSTALL SEAL (3).
40. INSTALL LEFT-HAND OUTPUT
a. Install new gasket (4).
HOUSING. See task REPLACE
b. Install seal (3) on shaft (5) with
LEFT-HAND OUTPUT HOUSING,
beveled end (6) toward housing (7).
END OF TASK
Change 2
4-344.1 (4-344.2 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals