 |
|||
|
|
|||
|
Page Title:
REMOVE HOSE TO BOSS ELBOW |
|
||
| ||||||||||
|
|
 TM 9-2520-270-34
9. CHECK BEARING BORE (3).
8. REMOVE HOSE TO BOSS
a. Using indicator caliper, measure
ELBOW (1) IF ATTACHED.
diameter of bearing bore (3).
a. Unscrew elbow (1).
b. If diameter of bearing bore (3) is
b. Remove and discard preformed
greater than 4.529 inches (115.04 mm),
packing (2).
go to step 11.1. If not, go to step 10.
11.
INSPECT SPINDLE (5) AND
BRAKE ASSEMBLY (6).
a. Inspect spindle (5) and brake assem-
bly (6) for damage. See page 2-5.
b. If brake assembly (6) is damaged, go
to step 11.1. If not, go to step 12.
11.1
REPLACE BRAKE ASSEMBLY (6).
RECORD FAILURE ON DA FORM 2407
AND RETURN DEFECTIVE BRAKE
10. CHECK PISTON BORES (4).
ASSEMBLY TO DEPOT. GO TO
a.
Using telescoping gage set and
STEP 13.
micrometer caliper set, measure
diameter of four piston bores (4).
12.
C L E A N RIGHT-HAND SINGLE DISK
BRAKE.
b.
If any piston bore (4) diameter is
greater than 2.122 inches (53.90 mm),
a. Clean assembly and hardware. See
go to step 11.1. If not, go to step 11.
4-204
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals