 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
CAUTION
Do not install bearing in hub side of gear.
Equipment can be damaged.
54. INSTALL NEW NEEDLE BEARING (1) IN
NOTE
TOW PUMP SPUR GEAR (2).
Gears are installed with raised hubs facing up.
a. If either bearing (1) was removed, go to
step 54b. If not, go to step 55.
55. INSTALL TWO GEARS (2).
b. Place bearing (1) on bearing installer
a. (H) Lower housing (4) to workbench.
(Item 12) with part number end (3) of
b. Install two thrust washers (5), gears (2),
bearing against installer.
and remaining two thrust washers (5).
c. Using arbor press and bearing installer,
c. Install two new retaining rings (6).
press bearing (1) into gear (2).
56. INSTALL TWO NEW BALL BEARINGS (7)
ON SPUR GEAR (8).
a. If either bearing (7) was removed, go to
step 56b. If not, go to step 58.
b. Using arbor press and bearing installer
(Item 7), press bearing(s) (7) onto
gear (8).
GO TO NEXT PAGE
4-194.1
Change 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals