 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
28. REMOVE BEARING (1).
Using screwdriver, remove retaining
a.
ring (2) from groove (3).
b. Turn housing (4) over. Have helper
assist.
27. INSPECT BALL BEARING (1).
Using drive punch, remove and discard
c.
a. Inspect bearing (1) for damage.
bearing (1).
See TM 9-214.
Discard bearing end plate removed in
d.
b. If bearing (1) is damaged, go to step 28.
step 18.
If not, go to step 34.
29. IF GEAR (5) WAS NOT REPLACED AND
BEARING (1) WAS REPLACED, GO TO
STEP 31.
30. IF GEAR (5) WAS REPLACED, GO TO
STEP 33.
31. REMOVE BEARING INNER RACE (6)
FROM SPUR GEAR (5).
a. Using two pry bars, slowly pry off
bearing inner race (6).
b. Remove and discard bearing inner
race (6).
32. CHECK SPUR GEAR (5).
a. Using indicator caliper, measure outside
diameter of inner hub (7).
b. Replace gear (5) if measurement is less
than 4.3312 inches (110.012 mm).
GO TO NEXT PAGE
4-189
Change 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals