 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
NOTE
Tube has a large opening and small opening.
Use small opening to slant ring onto guide.
U s e large opening to move it onto flat
shoulder of guide.
17. PRESS NEW RETAINING RING (1)
ONTO SNAP RING GUIDE (2).
a. Place wood block in arbor press.
b. Place guide (2) on block.
c. Put new ring (1) onto guide (2).
d. Set snap ring guide tube (3)
on new ring (1).
e. Using tube (3) press new ring (1) onto
guide (2) until seated on shoulder (4).
Remove from arbor press.
18. INSTALL NEW RING (1).
a. Place guide (2) with new ring (1) on
spline (5).
b. Slide tube (3) on guide (2).
c. Using plastic-faced hand hammer, tap
tube (3) until new ring (1) slides off
guide (2) into ring groove (6).
19. INSTALL DISCONNECT CLUTCH
ASSEMBLY. See task REPLACE
D I S C O N N E C T CLUTCH ASSEMBLY,
20. INSTALL DISCONNECT CLUTCH.
See task REPLACE DISCONNECT
CLUTCH, page 4-52.
END OF TASK
4-125
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals