Install two guide bolts

Place low and reverse piston housing assembly (A)

on work table, reverse end up. Install reverse clutch

Install two guide bolts (A) into pitot tube (B), and

apply plate (B), one internal-splined plate (C), and

insert guide bolts into housing (C). Install reverse

reverse ring gear (D).

planetary carrier and pitot collector ring assembly

(D) so that pitot tube (B) will be located in

collector ring at position shown by arrow head (E)

between vanes. (Guide bolts are part of set 4910-

572-8710 (8356165).)

Alternately install three external-tanged (A) and

three internal-splined (B) clutch plates. Install 12

springs (C) into reaction plate (D). Install reverse

Remove one guide bolt (A), and install a 1/4-28 x

clutch reaction plate assembly (D).

23/4 bolt (B) and plain washer to hold pitot tube in

NOTE

place. Remove other guide bolt, and install other

Aline anchor pin slot (E) with clutch apply

bolt and washer. Tighten bolts to 8 to 10 pound-

oil holes (F).

feet torque. (Guide bolts are part of set 4910-572-

8710 (8356165).)