Install two special bolts 4910-572-8701

Install two special bolts 4910-572-8701 (8356186)

(A) each side, through upper-rear bolt holes in

Using three puller bolts 4910-572-8699 (8356200)

p o w e r takeoff pads. Tighten bolts to 10 to 12

pound-feet torque. These bolts secure intermediate

(A) loosen and remove diaphragm assembly (B).

clutch back plate (B) during disassembly.

Remove shims (under diaphragm).

CAUTION

Tighten puller bolts (A) evenly to avoid

cramping diaphragm (B) in its bore.

NOTE

A needle bearing assembly and washer may

come off with diaphragm assembly. If they

did, inspect underside of diaphragm, and

remove them.