Install two gaskets

TM 9-2520-249-34&P

108 Install two gaskets (1 and 2) on the oil filter

housing mounting pads, using oil-soluble grease

to retain them. Install oil filter housing 13).

110 Install three 3/8-24 x 1 1/8 bolts (1) and three

lockwashers. Tighten the bolts to 33 to 40

pound feet torque. Set the torque converter

housing assembly to one side until ready to

attach it to the bevel gear housing assembly.

109 Install four 3/8-16 x 5 3/4-inch bolts (1), four

plain washers, and four lockwashers. Tighten

the bolts to 20 to 24 pound feet torque. Install

O-type seal ring (2) on filter screen assembly (3)

and install the assembly into the filter housing.

111 Install locknut (2) onto brake adjusting screw (3)

on left side. Install the bolt and nut into the lug

on brake rotating cam (1)

NOTE

Install the brake adjusting screw so

that the threaded end does not

project through the rear of the lug.

Leave the locknut loose. Repeat the

installation procedure on the right

side

8-38