 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-249-34&P
87 The procedures outlined in step 88, following.
are necessary to space the transmission
properly in relation to the transmission driving
88 Attach sling(1), (25, table 3-11 to torque
disk (on engine). If correct spacing is not
converter pump cover (2) and use a hoist to
established, the driving disk will be subject to
apply sufficient lifting force 150 to 100 Ib to
strains which will cause its failure and possible
eliminate all end play. Position straight-edge (3)
transmission damage. The above figure shows
on the converter pump cover, as shown. Using
the correct spacing. stack control spacers, and
a micrometer depth gage (5), measure and
spacer retainers.
record dimension (6).
Subtract height of
straight-edge (dimension (4), from dimension
(6)), and record the difference. Subtract this
difference from 1.566 inches. Select spacers
which will equal (within 0.010 inch, plus or
minus the resulting dimension. This is the
proper spacer thickness to be used at each
drive stud. Remove sling (1).
8-32
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals