Install 12 steel balls

TM 9-2520-249-34&P

NOTE

When installing the cam. the flat area (2) on

the largest circumference must be at the top

and inclined slightly toward the rear of the

bevel gear housing.

44 Using handle and adapter (1), (14 and 2, table

42 Install 12 steel balls (1) into the pockets in

3-1) install right output clutch assembly (2) in

stationary cam (2), retaining them with oil

housing. Remove the handle and adapter.

soluble grease. Install right brake rotating cam

(3) and seat it against the steel balls. Rotate the

cam counterclockwise to the maximum released

position.

43 Position right output housing assembly (1) on

wood blocks. Aline hole (2) in piston (3) with

anti rotation pin (5) in the housing and install

45 Using lifting sling (1), (25, table 3-1) install

piston assembly (3) with its seal rings. Make

brake assembly (2), steer clutch assembly (6),

certain two seal rings (4) are in place on output

and spacer assembly (7) as a unit. Aline the

ground sleeve.

bolt holes in the spacer with those in the

housing. Grasp the sling with one hand and

while rotating sun gear (5) back and forth, move

the

assembly

8-19