Install steer coolant check valve retainer assembly

TM 9-2520-249-34&P

36. Install steer coolant check valve retainer

37. Install reverse-range planetary carrier assembly

assembly (2) with its seal ring. Pin (31 extends

(1), with its two seal rings (2).

through the retainer approximately 3/16 inch

and must be indexed with hole (3, step 35,

above). Install four 5/ 16-18 x 1 1/2-inch,

selflocking bolts (4) and four plain washers in

the retainer assembly and tighten them only

finger tight. Install eight anchor pins (1) through

the retainer and seat them into the output

housing. Tighten four bolts (4) to 17 to 20

pound feet torque.

38. Install splined spacer (1) and snapring (2) onto

cross shaft (3). Note hole (4). (Refer to

8-17