Place bevel gear housing - TM-9-2520-249-34-P0171

TM 9-2520-249-34&P

13 Install steer coolant check valve retainer

assembly (1), with its seal ring. Pin (3) extends

through the retainer approximately 3/ 16 inch

and must be indexed with hole (2).

12.

Place bevel gear housing (1) on wood blocks in

an upright position. Install reverse-range clutch

piston assembly includes inner and outer seal

rings. Install gasket (3), cover (4), eight 3/8-16

x 1 3/8-inch bolts (5), eight lock washers.

Tighten the bolts to 36 to 43 pound feet torque.

NOTE

Items (3, 4 and 5), above, used only on

earlier models.

14. Install four 5/16-18 x 1 1/2-inch, self-locking

bolts (3) and four flat washers to secure retainer

assembly (2). but do not tighten. Install reverse-

range planetary carrier assembly (1). Make

certain two seal rings are installed on it.

8-10