Figure 7-32. Installing double-row ball bearing onto output shaft.

TM 9-2520-249-34& P

Figure 7-33. Installing spindle into steer planetary

carrier.

Figure 7-32. Installing double-row ball bearing onto

output shaft.

h. Using spindle replacer (22, table 3-1), and

indexing the spindle and replacer, install the spindle into

b. If baffle (3, FO-9) was removed from

the carrier. Press the spindle flush with, to 0.010 inch

carrier (4), install a new one. Stake the baffle plate two

below, the spindle bore surface of the carrier (fig. 7-33).

places at each of three locations around the inside

Install pin (7.7, FO-9) into carrier (4).

diameter of the baffle to secure it to the carrier.

Press the pin 0.030 to 0.090 inch below the pin bore

c. Grease the bore of a pinion (7.3) with a

surface of the carrier outside diameter. Stake carrier

liberal amount of oil-soluble grease.

metal over the pin at two places.

d. Install a spacer (7.2) and a thrust washer

Install the remaining five pinions (7.3) with

(7.1) onto one side of pinion (7.3) with oil-soluble

their components, and pins (7.7), into the carrier in the

grease.

same manner as described in c through i, above.

e. Insert 25 pinion rollers (7.4) inside pinion

k. Install oil collector (5) on carrier (4) and

(7.3) around the bore wall.

secure it with six 5/16-24 x 5/8 bolts (6). Bend a lock

Install another spacer (7.5) and a nother

tab on the oil collector against the head of each bolt (6).

thrust washer (7.6) on the other end of pinion (7.3).

Install shaft assembly (8) into steer

g. Install the pinion with rollers, washers and

planetary carrier assembly (2) Insert the shaft through

spacers into the carrier using an alinement tool of

the side of the carrier opposite oil collector (5).

replacer (22, table 3) to aline the pinion components

with the spindle bore in the carrier. Refer to figure 7-33.

7-29