Reverse Gear Rear Bearing.

TM 9-2520-246-34

NOTE

Use an arbor press to install the output shaft

Use a wooden block when tapping the end

front bearing on the output shaft.

roller bearing into the housing. Coat the

thrust washers with grease, automotive and

k. Shifter Shaft Boot and Seal. Using a blunt rod,

artillery (GAA), MIL-G-10924; this holds

tap the seal and boot from the seat in the counter

the washers in position for installation of

bore. (See fig. 5-15.) It is not necessary to remove the

the reverse gearshaft.

seal unless it is damaged.

i. Reverse Gear Rear Bearing.

NOTE

Using an arbor press or a soft drift pin, remove

During installation tap the boot into the

the reverse gearshaft rear bearing from the housing.

seat using a small wooden block. Work

around the base of the boot until it is

evenly seated. If the seal was removed,

NOTE

install the seal first. Tap the seal into place

with a suitable arbor or wooden dowel.

When installing reverse gearshaft rear

bearing into the housing, tap the bearing

into position with a block of wood and

hammer so as not to damage the bearing.

Figure 5-13. Removal of Reverse Gearshaft

Rear Bearing.

j. Output Shaft Front Bearing. Using a universal or

suitable puller, pull the output shaft front bearing

from the shaft. (See fig. 5-14.)

Figure 5-15. Removal of Shifter Shaft Boot and Seal.

Figure 5-14. Removal of Output Shaft Front Bearing.

5-6