Output and Reverse Shaft Rear Bearing Cap.

TM 9-2520-246-34

Figure 5-7. Removal of Output and Reverse Shaft Rear

Figure 5-5. Removal of Input Gearshaft.

Bearing Cap.

(2) Remove the four capscrews and star washers

(2) Lift the gear from the case and remove the

securing the output shaft front bearing cap to the

roller bearings from the gear, then remove the thrust

power takeoff. Remove the output shaft front bearing

washers from the respective positions. (See fig. 5-6.)

cap and gasket. Discard the gasket.

d. Output and Reverse Shaft Rear Bearing Cap.

NOTE

(1) Remove the five capscrews and star washers

On assembly, always install a new gasket.

securing the rear bearing cap to the power takeoff

case. (See fig. 5-7.) Remove the rear bearing cap and

NOTE

cap gasket. Discard the gasket.

Do not remove the output shaft front

NOTE

bearing cap unless seal replacement is

required. If seal is to be replaced, remove

On assembly, always install a new gasket.

with suitable tool. Install by pressing or

driving against the seal with a wooden

(2) Remove the output shaft rear bearing spacer

block.

in front of the output shaft rear bearing.

e. Output Shaft Front Bearing Cap and Companion

Flange Key.

(1) Remove the output shaft key from the output

shaft. (See fig. 5-8.)

Figure 5-8. Removal of Output Shaft Front Bearing Cap

Figure 5-6. Removal of Input Gear, Gear Roller

and Companion Flange Key.

Bearings, and Thrust Washers.

5-4