 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-238-34
REPAIR STEERING CONTROL DIFFERENTIAL HOUSING -- Continued
0029 00
NOTE
If inspection indicates resilient mounts require replacement, do Step 5.
5.
Remove resilient mounts (1). Use remover and replacer.
6.
Turn lifting eye (2) to left and remove from housing (3).
7.
Remove high oil temperature switch (4), pipe tee (5), and pipe nipple (6) from housing (3).
CLEANING
CLEAN, INSPECT, AND REPAIR
1.
Before inspection, repair, or assembly, clean all parts of steering control differential housing (WP 0014 00).
2.
Inspect all parts. Refer to (WP 0014 00) for general inspection and repair procedures. Check for minimum, maximum,
and important clearances of new or rebuilt parts, and for wear limits which determine when part will be replaced page
3.
Inspect surface of strainer and retainers for wear, scratches, cracks, and deformations. Remove minor defects. Replace
parts that can not be repaired.
4.
Inspect strainer mesh for enlarged holes and breaks. Repair damage or replace strainer.
5.
Inspect alignment pin holes in housing for elongation or other damage. Replace housing if holes are damaged beyond
repair.
0029 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals