WEAR LIMITS - TM-9-2520-238-340285

TM 9-2520-238-34

REPAIR STEERING CONTROL DIFFERENTIAL HOUSING -- Continued

0029 00

Clean threads of lifting eye (1). Apply a light coat of antiseize compound to threads.

Install lifting eye (1) in housing (2) by turning lifting eye to the right.

NOTE

If resilient mounts were removed in page 0029 00-2, do Step 7.

Install resilient mounts (3). Use remover and replacer.

Install new grommet (4) in strainer (5).

Place two retainers (6) in housing (2).

10. Place strainer (5) in housing (2). Secure to two retainers (6) with eight washers (7) and cap screws (8). Install new

lockwire (9) between screws on each retainer.

11. Install two new needle roller bearings (10) on right side housing (2).

12. Install two new needle roller bearings (10) on left side housing (2).

NOTE

If any alignment dowel pins were removed from housing in page 0029 00-2, do Step 13 and Step

14.

13. Install new alignment dowel pin (11) to protrude 21/32 inch (1.68 cm) from housing (2).

14. Install two new alignment dowel pins (12) to protrude 3/8 inch (.97 cm) from housing (2).

WEAR LIMITS

See TM 9-214 to check bearings.

0029 00-5