Install retaining plate

TM 9-2520-238-34

REPAIR TRANSFER GEARCASE F -- Continued

0019 00

27. Repeat Steps 23 - 26 above using retaining plate (9), retaining plate (10), retaining plate (11), laminated shim (2),

laminated shim (3), and laminated shim (4).

28. Lubricate new packing (12), packing (13), and packing (14) with grease or petrolatum. Install packings on retaining

plate (7), retaining plate (9), and retaining plate (10).

29. Install retaining plate (7), retaining plate (9), and retaining plate (10) on cover (5). Apply a light coat of antiseize

compound to clean threads of cap screw (8), cap screw (15), and cap screw (16). Place laminated shims (1), (2), and (3)

and retaining plate (7), retaining plate (9), and retaining plate (10) on cover. Secure plates with new key washer (6),

new key washer (17), new key washer (18), and cap screw (8), cap screw (15), and cap screw (16). Tighten screws to

252-300 lb-in (25-33 Nm) torque. Use torque wrench (WP 0033 00, Item 41). Bend tabs on key washers.

CAUTION

To prevent damage to encased oil seal, do not press seal beyond face of bore. After installation

seal must be flush with outer surface.

30. Clean mating surface of new encased oil seal (19). Apply a thin film of sealing compound (WP 0035 00, Item 12) or

(WP 0035 00, Item 13) to outer edge of oil seal. Install encased oil seal in first intermediate bearing retaining plate (10).

0019 00-19