Lubricate new packing - TM-9-2520-238-340167

TM 9-2520-238-34

REPAIR TRANSFER GEARCASE F -- Continued

0019 00

14. Lubricate new packing (1) with grease or petrolatum. Install packing and dust deflector (2) on shaft on disk assembly (3).

CAUTION

To prevent damage to encased oil seals, do not place housing in upright position until bearing

retainers are installed.

To prevent damage to encased oil seals, do not press seals beyond face of bore. After installation

seal must be flush with outer surface.

15. Clean encased oil seals. Apply a thin even film of sealing compound (WP 0035 00, Item 12) or (WP 0035 00, Item 13) to

mating surface of seal (4) and seal (5). Position each seal with lip toward bore. Use a flat block of wood and soft plastic

hammer to tap seals in place.

16. Align splines of disk assembly (3) with splines of output gear and insert disk assembly shaft into output gear.

0019 00-15