 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-238-34
REPAIR TRANSFER GEARCASE F -- Continued
0019 00
7.
If dowel holes exist in second intermediate gear (1) and primary pump-drive gear (2), align holes in each gear. Secure
gears together with new spring pin (3). Stake pin three equal places at both ends.
8.
If dowel holes do not exist in either second intermediate gear (1) or primary pump-drive gear (2), assemble gears and
drill a 0.375 to 0.380 inch diameter hole using a 3/8 inch drill bit. Use twist drill set and portable electric drill. Secure
second intermediate gear (1) and primary pump-drive gear (2) together with new spring pin (3). Stake pin three equal
places at both ends.
9.
If removed, install bearing cone (4) and bearing cone (5) on helical gearshaft cluster (6). Install helical gearshaft cluster
in housing (7) meshing teeth of second intermediate gear (1) with first intermediate gear (8).
10. If removed, install bearing cone (9) and bearing cone (10) on output gear (11). Install output gear in housing (7) meshing
teeth with second intermediate gear (1).
0019 00-13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals