 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-238-34
REPLACE TRANSFER GEARCASE A, B, OR C WITH SERVICE SPARE TRANSFER
0018 00
GEARCASE E -- Continued
9.
Apply antiseize compound to threads of two clean cap screws (17) at installation. Install bracket (14) on housing cover
(18) with two key washers (19) and cap screws. Tighten cap screws to 144-180 lb-in (17-20 Nm) torque. Use torque
wrench (WP 0033 00, Item 41). Bend tabs on key washers.
10. Install remote control lever (20) on engine disconnect actuator (21).
NOTE
Pin must be a press-fit into remote control lever on engine disconnect actuator. If necessary,
ream the pin hole with a 5/16 inch (31 cm) drill bit. Do not ream hole larger than 0.313 inch (.6
cm).
11. Secure remote control lever (20) to actuator (21) by pressing or driving grooved pin (22) into pin hole.
NOTE
This is an internal gear and is not
removed here. This is only shown
as a reference for the pump installation.
0018 00-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals