|
|
TM 746-10
Figure 3-19. Examples of Special Markings.
of 24 inches or more should employ the 9by 9-inch (6-
1. Rectangular containers, consolidation
inch disc) label, while containers with sides under 24
containers, and palletized loads. Two labels, one on
inches in length should use the 3by 3-inch (2-inch circle)
each side.
label.
2. CONEX containers. One disc on each
(a) ARI labels shall be applied with MMM-A-179
marking board. The 9- by 9-inch label is preferred.
adhesive placed both on the container and over the
However, if the board surface size is not sufficient to
label (1 inch on all sides) and with sufficient drying time
accommodate the larger label, then the smaller label
allowed (approximately 5 minutes). Labels shall be
shall be used.
applied as follows:
3-24
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |