|
|
TM 55-4920-325-14&P
CHAPTER
2
OPERATING
INSTRUCTIONS
Section
I.
INTRODUCTION
2-2 General.
2-1. Scope.
Adherence to the procedures set forth in the
This chapter contains information and in-
following sections will enable an operator with
structions for operating Capacitance Type Fuel-
limited experience to successfully operate the test
Quantity-Gage Test Set, Part Number TF579. Op-
set. Perform the required procedures in the se-
erating instructions for measuring the capacitance
quence given in order to assure proper operation
of tank unit probes is contained in Section II of
of the equipment. Operating personnel should be
this chapter. Section Ill contains operating in-
thoroughly familiar with the location and function
structions for measuring the tank unit probe in-
of all operating controls, indicators, and con-
sulation resistance. Instructions for the use of the
nectors before attempting to make any mea-
test set to simulate the capacitance of a tank unit
surements or tests.
probe (or probes) to check the aircraft fuel quan-
tity gage is contained in Section IV. Section V
2-3. Operating Controls, Indicators and
contains operating instructions for measuring air-
Connectors.
craft wiring leakage resistance.
The location of operating controls, indicators,
and connectors are shown in figure 2-1. The func-
tion of these controls are described in table 2-1.
Figure 2-1. Control Panel Operating Controls, Indicators end Connectors.
2-1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |