Appendix C. REPAIR PARTS AND SPECIAL TOOLS LIST

TM 55-4920-201-14

APPENDIX C

REPAIR PARTS AND SPECIAL TOOLS LIST

(Current as of 26 October 1971)

Section I. INTRODUCTION

C-1. SCOPE.

This appendix lists the components required for the performance of direct and general support

maintenance of the propeller balancing and adapter kits.

C-2. GENERAL.

This basic issue item, repair parts and special tools list is divided into the following sections:

a. Basic Issue Items - Section II. Not applicable.

b. Maintenance and Operating Supplies - Section III. Not applicable.

c. Prescribed Load Allowances - Section IV. Not applicable.

d. Repair Parts (ORG) - Section V. Not applicable.

e. Special Tools, Test and Support Equipment (ORG) - Section VI. Not applicable.

f. Repair Parts (DS/GS) - SectionVII. A list of components authorized for the performance of

maintenance at the direct and general support levels in figure and item number sequence.

g. Special Tools, Test and Support Equipment (DS/GS) - Section VIII. Not applicable.

h. Federal Stock Number and Reference Number Index - Section IX. This section is divided as

follows:

(1) A list of Federal stock numbers in ascending numerical sequence, cross-referenced to the

illustration figure and item number.

(2) A list of reference numbers in ascending alphanumerical sequence cross-referenced to the

manufacturer's Federal supply code and illustration figure and item number.

C-3. EXPLANATION OF COLUMNS.

The following provides an explanation of columns in the tabular lists in section VII.

a. Source, Maintenance and Recoverability Codes (SMR), Column 1.

(1) Source code. Indicates the selection status and source for the listed item. Source codes are:

Explanation

Code

Repair parts, special tools and test equipment supplied from the GSA/DSA or Army supply

system and authorized for use at indicated maintenance categories.

Repair parts, special tools and test equipment which are procured and stocked for insurance

purposes because the combat or military essentiality of the end item dictates that a minimum

quantity be available in the supply system.

Assigned to items which are NSA design controlled: unique repair parts, special tools, test,

measuring, and diagnostic equipment which are stocked and supplied by the Army COMSEC

Logistic System and which are not subject to the provisions of AR 380-41.

P10

Assigned to items which are NSA design controlled: special tools, test, measuring, and

diagnostic equipment for COMSEC support which are accountable under the provisions of

AR 380-41 and which are stocked and supplied by the Army COMSEC Logistic System.

Repair parts, special tools and test equipment which are not procured or stocked as such in

the supply system but are to be manufactured at indicated maintenance levels.

Assemblies which are not procured or stocked as such but are made up of two or more units.

Such component units carry individual stock numbers and descriptions, are procured and

stocked separately, and can be assembled to form the required assembly at indicated

maintenance categories.

Parts and assemblies that are not procured or stocked because the failure rate is normally

below that of the applicable end item or component. The failure of such part or assembly

should result in requirement of the end item from the supply system.

C-1

Change 1