Figure 4-62. Guiding Fingers of Release Yoke over Release Sleeve Collar.

TM 55-1930-208-24

(17) With the clutch drive shaft, clutch release shaft, and yoke assembled in the housing, install the clutch

assembly on the drive shaft as follow s:

(a) Support clutch housing and drive shaft assembly on wood blocks with the drive shaft in a horizontal

position and inspection hole in the clutch housing facing up.

(b) Lubricate the inside diameter of the clutch release sleeve with engine oil (item 8, Appendix C). Start

the clutch assembly over the tapered end of the clutch drive shaft with the keyway in the hub of the

outer pressure plate in line with the keyway in the clutch drive shaft. Position the clutch release

sleeve collar so the tapped hole in the side of the collar is in proper relation to the flexible tube hole

in the side of the clutch housing, so that the flexible grease tube can be connected at each point;

then guide the fingers of the release yoke over the trunnions on the release sleeve collar as shown in

Figure 4-62. Guiding Fingers of Release Yoke over Release Sleeve Collar.

shaft, then insert key (28, figure 4-57) in the keyway and tap it into place with a punch and hammer.

(d) Place lockwasher (7) on the drive shaft against the outer pressure plate with the tang on the inner

diameter of the lockwasher in the keyway in the pressure plate.

(e) Install clutch drive shaft nut (6).

4-87