Reassembly. - TM-55-1930-208-240315

TM 55-1930-208-24

4-17. CLUTCH REPAIR-Continued.

b. Cleaning, Inspection, and Repair-Continued.

(9) Inspect the keyways in the clutch drive shaft and if the shaft is excessively peened or damaged so that the

keys have a tendency to "roll", the shaft must be replaced.

(10) Check for weak or broken pressure plate separator springs.

c. Reassembly.

(1) Place the inner clutch pressure plate (44, figure 4-57) on a bench. Be careful to avoid damage to the

finished face of the pressure plate.

(2) Attach clutch release levers to the inner clutch pressure plate a follows:

(a) Place a clutch release lever spring (43) over one of the lever bosses on the inner pressure plate with

the open ends of the spring against the outside face of the pressure plate.

(b) Place a clutch release lever (42) in the slot in the boss with the end of the lever under the closed end

of the spring.

boss, and lever. Secure the pin in place with washer (39) and retaining ring (38).

(d) Install the three remaining clutch lever springs and levers in the same manner.

(3) Place the outer pressure plate (30) on a bench with the hub end of the pressure plate up.

(4) Place the center clutch pressure plate (31) over the hub of the outer pressure plate with the teeth of the

center plate in mesh with the splined grooves in the hub of the outer plate.

(

5) Place the assembled inner clutch pressure plate, inner face down, over the hub of the outer clutch pressure

plate with the teeth of the inner plate in mesh with the splined grooves of the outer plate.

(6) Install the clutch adjusting ring (37) as follows:

(a) Attach the adjusting ring wear plate (33) to the clutch adjusting ring (37) with screws (32).

(b) Attach the adjusting ring lock (35) and adjusting ring lock spring (36) to the adjusting ring with screw

(34).

plate with wire.

4-82