Figure 4-58. Loosening 14 Inch Diameter Clutch Assembly from Clutch Drive Shaft.

TM 55-1930-208-24

4-17. CLUTCH REPAIR-Continued.

a. Clutch Disassembly-Continued.

(8) Attach puller bar J8190, puller legs J8180 and adapters J6471-5 to the forward face of the clutch assembly

as shown in figure 4-58. Turn the puller screw to loosen the clutch assembly. Remove the clutch facings

(11, figure 4-57) when they clear the clutch housing.

Figure 4-58. Loosening 14 Inch Diameter Clutch Assembly from Clutch Drive Shaft.

(9) Remove the clutch assembly from the clutch drive shaft and place it on a bench with the forward face

down.

(10) Remove the chain wrench and the clutch retaining key (12, figure 4-57) from the clutch drive shaft.

(11) Slide the clutch release sleeve and release sleeve collar assembly (13) off the clutch drive shaft.

(12) Remove hand lever attaching bolt (14), lockwasher (15), then slide the hand lever (16) off the shaft.

(13) Remove two yoke clamping bolts (17) and two lockwashers (18) from clutch release yoke.

(14) Slide clutch release yoke (19) to the right or left and the clutch release shaft (20) in the opposite direction

until the two woodruff keys (21) are free from the yoke.

(15) Remove two woodruff keys from shaft and withdraw the shaft from the housing and yoke.

(16) With the clutch assembly removed from the clutch drive shaft, remove the drive shaft from the housing as

follows:

(a) Remove bearing retainer lock plate bolt (22), lockwasher (23), and bearing retainer lock plate (24) from inside

clutch housing.

4-78