Cleaning. - TM-55-1930-208-240247

TM 55-1930-208-24

4-9. WINCH, ANCHOR - Continued.

c. Cleaning.

WARNING

Do not breathe cleaning solvent P-D-680 vapors for long periods of time or use solvent

near open flames. To avoid illness, explosion, or fire, only use solvent in well-ventilated

areas away from open flames.

(1) Clean all parts with cleaning solvent (item 4, Appendix C).

(2) Allow all parts to dry.

d. Inspection.

(1) Inspect all shafts for nicks, burns, or signs of wear.

(2) Inspect drum gear for chipped or broken teeth.

(3) Inspect all hardware for damaged threads.

(4) Inspect bearings for pitting and signs of wear.

e. Repair. Repair is limited to replacing defective parts.

f. Reassembly.

(1) Refer to figure 4-4 and install lever (56), holding dog (55), and two washers (54).

(2) Install ratchet lever (53), ratchet dog (52), two washers (51), shaft (50), two retaining rings (49), guide (48),

spring (47), washer (46), and pin (45).

(3) Press bearings (41) into side frames (36 and 40). Position side frames (36 and 40) into position and install

gusset (39), washer (38), and shaft (37).

(4) Install key (44) and wheel (43). Install pin (42) into side frame (36). Install stop (25) and s cure with bolt

(24).

(5) Install two shafts (33), cover (32), two tubes (31), two studs (30), and four nuts (29).

(6) Install two brackets (28) and secure with two bolts (27). Install lever extender (26).

(7) Press bearing (25) into drum (34). Position drum (24) into place and install blocking under drum. Install

shaft (22) by driving in with a rod and maul. Remove blocking and install wedge (23).

4-14